|
The Elma Bustronic's extender boards are available in various bus architectures. They aid in prototyping and testing by extending the signals outside of the card cage.
|
. |
220mm/400mm VME Test Extender
|
All models of our VMEbus high performance J1, or J2, or J3 extender boards extend all 96 signals, including power and ground per the ANSI/VITA 1-1994 specification.
Datasheet (132 KB) 
|
VME64x Test Extender
|
Elma Bustronic VME64x test extenders have been designed to comply with the mechanical and signal connection requirements of the ANSI/VITA 1.1 – 1997 VME extensions standard.
Datasheet (176 KB) 
|
VXI Test Extender
|
The VXI test extender board is designed to meet mechanical and electrical connection requirements of VXIbus spec., Rev. 1.4, VMEbus C.1.
Datasheet (51 KB) 
|
cPCI Test Extender
|
Elma Bustronic CompactPCI test extenders have been designed to meet mechanical and electrical connection requirement of PICMG 2.0 Rev 3.0.
Datasheet (246 KB) 
|
ATCA Test Extender
|
The ATCA extender board extends both the power and IPMB (Intelligent Platform Management Bus) signals. With a 10-layer stripline design, the extender is designed for the full populated fabric slot (5 ZD connectors, P20 thru P24) and the power connector J10. The Zone 3 section is served by a blind board assembled to Zone 1+2 through the frame. The flexible design of the Zone 3 area allows for customization with minimum costs, by simply only changing the blind board the required configuration. The complete keying system, including the Zone 3 area is assembled.
Datasheet (62 KB) 
|
VXS Test Extender
|
Elma Bustronic used creative engineering to solve a major problem in developing the VXS Extender Board - the lack of a right angle receptacle for VXS in the marketplace. So, the company produced a rigid-flex-rigid PCB design to get around the problem. The solution entails a right angle pin connector that plugs into the backplane, connected to a flex circuit that wires to the straight receptacle to receive the plug-in board.
Datasheet (39 KB) 
|
6U VPX Test Extender
|
Elma Bustronic used creative engineering to solve a major problem in developing the VPX Extender Board - the lack of a right angle receptacle for VPX in the marketplace. So, the company produced a rigid-flex-rigid PCB design to get around the problem. The solution entails a right angle pin connector that plugs into the backplane, connected to a flex circuit that wires to the straight receptacle to receive the plug-in board.
Datasheet (256 KB) 
User Manual (340KB) 
|

Load Boards
Form Factor Extender Boards
Power Interface Boards
RTMs
Rear Extender Boards
SerDes Test Modules
System/Voltage Monitors
Cabling Systems
VPX Power and Ground Backplanes
Other Accessories
 |

You
will need to view PDF files. |
|